Publicidad
Idiomas disponibles
Idiomas disponibles
Example:Press the PRESET button until the preset number 12
"P- 12" appears.
OR
Preset Tuning using the Remote Control (Possible
only after presetting stations)
Select the station by entering its preset number on the number
keys.
•
Example:For channel 5, press 5. For channel 15, press +10
then 5.
•
The band and the frequency are displayed.
3. Turn the antenna for best reception.
•
For FM broadcast, extend and turn the telescopic antenna.
•
For AM broadcast, turn the Unit itself.
For FM
Presetting Stations
You can preset up to 15 FM stations and up to 15 AM stations into
memory using the Remote Control.
Auto Presetting (Using the Unit) —
In each band, you can automatically preset FM-15, AM-15 stations.
Preset numbers will be allocated as stations are found, starting from
the station currently tuned to and moving up the frequency.
1. Select a band (AM or FM) by pressing the
TUNER BAND button.
2. Press the PRESET button for more than two
seconds.
3. Repeat steps 1-2 for the other band.
If you want to change any of the auto preset stations, follow the
procedure for Manual Presetting.
CAUTION: If the Unit is unplugged or if a power
failure occurs, the preset stations will be erased
after approx. five minutes. If this happens, you
will need to preset the stations again.
Using the CD Player
Number keys
REPEAT
6
¢
7
4
REMOTE CONTROL RM-SRCBZ5
All manuals and user guides at all-guides.com
For AM
CD holder
CD OPEN
Manual Presetting (Using the Re-
mote Control) ————————————
Number key(s) (hold for 2 seconds)
1. Select a band by pressing the TUNER
BAND button.
4
¢
2. Press the
or
3. Set the preset number by pressing and hold-
ing the number key on the Remote Control.
•
To preset numbers 1 to 10: Press the number key and hold
down for 2 seconds.
•
To preset numbers 11 to 15: Press and release the +10 but-
ton, then press the second number key (1 to 5) and hold
down for 2 seconds.
When the preset display blinks, the setting is stored and you can
release the number key. The display returns to the normal band
and frequency display.
Example: Preset number = 12
4. Repeat steps 1 - 3 for each station.
To change the preset stations, repeat the same steps as above.
To Change the FM
Reception Mode
The "STEREO" indicator lights up and you can hear stereo effects,
when a program is broadcast in stereo.
However if an FM stereo broadcast is hard to receive or noisy, you
can select Monaural mode. Reception improves, but you lose any
stereo effect.
Press the TUNER BAND button to select FM
MONO mode.
The "MONO" indicator lights up on the display.
To restore the stereo effect, press the TUNER BAND button
to select FM Auto mode. The "MONO" indicator goes out.
4
¢
7
Track number
(Display when using the CD Player)
button to tune in a station.
REPEAT
6
Repeat indicator
Playing time, Preset number
5
Publicidad
