Resetting The Unit - Winix ZERO-N Manual De Usuario

FILTER CARE

2. Resetting The Unit

After replacing the filters, turn the power
①
back on and then use a thin object, such as
a paper clip, to press the RESET switch for
5 seconds.
3. Cleaning the Fabric Pre-filter
Intervals between filter cleaning may vary depending on the air quality.
Use a vacuum cleaner or soft brush to clean
①
the Fabric filter. If it is excessively soiled,
rinse in room temperature water.
ˍ Do not use detergent or soap.
ˍ Allow the filter to dry for 24 hours or
more before using
※ If the Fabric Pre-filter becomes damaged
or in any way needs replacement:
Please contact your local
dealer
NOTICE
English
ZERO-N.indb 15
ˍ Do not use benzene, alcohol, or other volatile fluids, which
may cause damage or discoloration.
ˍ The Fabric Pre-filter is reusable after cleaning, ensuring it is
completely dry.
ˍ Do not use hot water over 40
paint thinner.
ˍ After washing the filter, allow it to dry completely in a well
ventilated area. Otherwise, it may develop a bad odour.
o
C or volatile fluids such as
ZERO-N
2018-04-26 오후 5:38:55
15