Information About Residual Risks That Cannot Be Eliminated - Hitecsa EQPL-B 4360 Manual Del Operador

I.7 PED CATEGORIES OF PRESSURE
COMPONENTS
List of PED critical components (Directive 97/23/EC):
EQPLB-EQPLBS
Component
Compressor
safety valve
High pressure switch
Low pressure switch
Finned coil/micro-channels
Heat exchanger
Pipes
RC100 recovery
Desuperheater DS
Unit
Shell and tube (STE accessory)
Unit with STE accessory
EQPL-EQPLBSS
Component
Compressor
safety valve
High pressure switch
Low pressure switch
Finned coil/micro-channels
Heat exchanger
Pipes
RC100 recovery
Desuperheater DS
Unit
Shell and tube (STE accessory)
Unit with STE accessory
EQPHB-EQPHBS
Component
Compressor
safety valve
High pressure switch
Low pressure switch
Finned coil
Heat exchanger
Pipes
RC100 recovery
Liquid receiver
Gas separator
Desuperheater
Unit
Tube and shell (STE accessory)
Unit with STE accessory
EQPH-EQPHBSS
Component
Compressor
safety valve
High pressure switch
Low pressure switch
Finned coil
Heat exchanger
Pipes
RC100 recovery
Liquid receiver
Gas separator
Desuperheater
Unit
Tube and shell (STE accessory)
Unit with STE accessory
4360-4435 5500-6540 6590÷8860
PED category
II II
IV IV
IV IV
- -
I I
II II
I I
II II
I I
II II
II III
II III
4385 4415 4460÷8920
PED category
II II
IV IV
IV IV
- -
I I
II II
I I
II II
I I
II II
II III
II III
4360÷6540 6590÷8860
PED category
II II
IV IV
IV IV
- -
I I
II III
I I
II III
III III
III III
I I
III III
III III
III III
4385÷4415 4460÷8920
PED category
II II
IV IV
IV IV
- -
I I
II III
I I
II III
III III
III III
I I
III III
III III
III III
I.8 INFORMATION ABOUT RESIDUAL RISKS
THAT CANNOT BE ELIMINATED
If any risks remain in spite of the provisions adopted, these are
II
indicated by adhesive labels attached to the machine in compliance
IV
with standard "ISO 3864".
IV
- CHILLER:
I
III
I
III
I
III
III
III
II
IV
IV
-
I
III
PDC:
I
III
I
III
III
III
55
IMPORTANT!
Pay the utmost attention to the signs and symbols
located on the appliance.
Indicates the presence of live components
Indicates the presence of moving parts
(belts, fans).
Indicates the presence of hot surfaces
(cooling circuit, compressor heads).
Indicates the presence of sharp edges on finned
coils
SECTION I :: USER