Erreka IZAR IZ1C Manual Del Instalador página 37

6
ELECTRICAL CONNECTIONS

Complete the installation in line with low
voltage regulations and applicable rules.

Use cables with sufficient section, always
earthed.

Check the manufacturer's instructions for all
the elements installed.

Current regulations
magnetothermic switch to feed the control
board must be fitted. The contact separation at
all poles must provide a total disconnection
under category III overvoltage, in accordance
with installation regulations.
characteristics (rated current, voltage, etc.)
must be suitable for the facility and the
elements used.
Case A: operator with encoder (IZS1 - IZS4 - IZS4D) with VIVO-D102(M) board
IZS4D
state that a
Its specific
VIVO-D102(M)
P113F
UNPACKING AND INSTALLATION
O
The operating voltage of the control board
must match the mains voltage (230VAC/ 50-
60Hz for the VIVO-D102, VIVO-D103/ADB30,
VIVO-D203; 125VAC/ 50-60Hz for the VIVO-
D102M, VIVO-D203M).
O
These operators do not require capacitors for
operation.
1 Connect the operator to the control panel as shown
in the diagram.
Cable colours:
G1 Blue (motor)
G2 Red (motor)
– Mesh (encoder mass: GND, P14)
S Green (encoder signal: SNG1, P15)
+ Brown (encoder supply: V+, P13)
IZS4D Operator with release: connect the STOP
cable connectors of the operator to the STOP cable
connectors of the control board.
IZS1, IZS4 Operators without release: make an
electrical bridge in the STOP cable connectors of the
control board.
2 Connect the control panel to the electricity supply
(see the control panel manual).

Before carrying out any door movement,
ensure there is no person or object in the radius
of action of the
mechanisms.
3 Check the turning direction of the operator using
the OPEN (OP) and CLOSE (CL) keys on the control
panel.
door and the drive
IZAR chain transmission operator
37