Descargar Imprimir esta página

cecotec bolero DRESSCODE 7300 Inverter A Manual De Instrucciones página 80

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
ENGLISH
4. OPERATION
Note
Please make sure the appliance is properly installed before operation.
-
-
Before washing the clothes for the first time, the product shall be operated in one round
of the whole procedures without the clothes inside.
-
All washing machines are thoroughly checked before leaving the factory and undergo
quality control. There may be a small amount of residual water in the drum. To remove it,
as well as to neutralise possible odours, it is recommended to clean the drum before the
first use. You can run a "Cotton" programme at 90°C without laundry and detergent.
Calibration
-
It is advisable to calibrate the washing machine before its first use in order to get the best
performance from it.
-
The device is able to detect the amount of laundry in the drum. Calibration optimises
product performance by minimising water and energy consumption.
-
To perform the calibration, follow the steps below:
1. Remove any objects from the drum and close the door.
2. Plug the power cord into the outlet.
3. Switch on the machine and press the "Delayed Start" and "Temperature" buttons
simultaneously for about 10 seconds until the control panel displays "t19".
4. Next, to start the washing machine, press the Start/Pause button. The drum will start to
rotate slowly, and the display will show different numbers, when it shows a steady figure
the washing machine is calibrated, you can turn the device off.
Start of washing
Before washing. Fig. 11
1. Plug the appliance into a power supply.
2. Open the water supply tap.
3. Load the washing machine with the laundry.
4. Close the door.
5. Add detergent (and softener if necessary).
Note
-
Detergent must be added in "case I" only after selecting pre-washing for machines with
this function.
-
Make sure that the washing machine is properly installed before use.
Washing. Fig. 12
1. Turn the knob to select the desired programme.
2. Select function or use the default one.
3. Press Start.
BOLERO DRESSCODE 7300/8300/9300/10300
80

Publicidad

loading