cecotec bolero DRESSCODE 7300 Inverter A Manual De Instrucciones página 94

ENGLISH
Pre-Wash
1. Select a programme.
2. Press "Function" button and select "Prewash" to make the appliance perform an
additional wash before the main wash cycle starts, to increase the washing performance
("Prewash" icon will light up).
Note: detergent must be added to compartment I.
Cleaning the drum
After the machine runs a preset period of wash cycles, the Drum Clean light will flash at
-
the end of the last programme, reminding you to run the programme as follows:
1. Empty the drum and close the door.
2. Press "Drum Clean".
3. Press "Start/Pause".
- The number of wash cycles will count back from 0 when the drum cleaning programme is
finished.
- If you want to remove the drum cleaning warning:
Press and hold the "Drum Clean" button for about 3 seconds, the warning will be
-
cancelled and the wash cycles will restart counting from 0.
Temperature (6)
When necessary, the wash temperature can be adjusted by pressing the button and following
the sequence below: Cold-20ºC-40ºC-60ºC-90ºC
Mute Mode
1. Select a programme.
2. Press and hold the Speed button for approx. 3 seconds. No beeps shall be heard.
3. To reactivate the sound, press the Speed button again for about 3 seconds.
Note: the setting will be saved until next restart.
Child Lock
Press the Temp and Function buttons at the same time for about 3 seconds.
-
Please note
When the child lock is activated and the washing programme starts, the display will
-
alternately show "CL" and the remaining time of the washing cycle.
Pressing any button will cause the indicator to flash.
-
- When the wash cycle is finished, "Cl" and "END" alternate on the display.
Press and hold the two buttons Temp and Function to unlock the function.
-
- This function locks all buttons except the Start/Pause button and the child lock button
itself.
- Deactivate the child lock function before selecting a programme and starting washing.
BOLERO DRESSCODE 7300/8300/9300/10300
94