Brandt BPI6449BL Manual De Instrucciones página 22

4.4
CHILD SAFETY
Your hob has a child safety device which locks
the controls when the hob is not in use or when
it is being used for cooking. Due to safety
reasons, the
authorises the heating zones to be switched off
even when locked.
Locking:
Press until the locking symbol
disappears and a beep confirms your operation
(4.4).
The cooking zones that are active are then
displayed,
alternating between the power and the locking
symbol.
Unlocking:
Press until the locking symbol
disappears and a beep confirms your operation.
CLEAN LOCK function:
The Clean Lock function permits the temporary
locking of your hob while it is being cleaned.
To activate the Clean Lock function, perform a
short press on the
the symbol flashes. After around
1 minute, locking is automatically deactivated.
Two beeps will sound and the
disappear. You can stop the Clean Lock function
at any time by holding down the
4.5
Recall- function (
This function lets you display the last "power and
timer" settings for all the burners which were
switched off less than 3 minutes previously.
The hob must be unlocked to use this function.
Press the On / Off button then perform a short
press on the button.
When the hob is operating, the function lets you
see the power and timer settings for the
burner(s) which have been switched off for less
than 30 seconds.
key remains active and
key; a beep sounds and
symbol will
button.
button)
4.6
SAFETY PRECAUTIONS AND
RECOMMENDATIONS
Residual heat:
After intensive use, the cooking zone that you
have just used can remain hot for several
minutes.
The "H" symbol is displayed during this period
(4.6.1).
Avoid touching the areas concerned during this
time.
Anti-overheat protection:
Each cooking zone has a safety sensor that
constantly monitors the temperature of the
bottom of the cookware. In the event that empty
cookware is left on a cooking zone that is
switched on, the hob automatically lowers the
power output and thus limits any risk of
damage.
Protection against overflows:
A special display (symbol
followed with the hob switching off, may be
triggered in the following cases:
- Overflow that spills onto the buttons (4.6.2).
- Metallic object placed on the buttons (4.6.3).
Remove the object or clean and dry the buttons,
then restart cooking.
Auto-stop:
Your hob has an auto-stop device, which
automatically stops any cooking zone which
remains switched on for an excessive length of
time (between 1 and 10 hours depending on the
power used).
If this safety system is triggered, the cut-off to
the cooking zone is shown with the "AS" display
on the control panel and a beep sounds for about
2 minutes. Simply press any of the buttons to
stop this.
Sounds which are similar to those of a clock
mechanism may be given off.
These noises occur
working. They disappear or reduce depending on
the heating configuration. There may also be
whistling sounds depending on the model and
quality of your cookware. The noises described
are normal. They are related to induction
technology and do not indicate a problem.
Advice on how to save energy
When cooking with the grill or empty
cookware, we recommend that you do not use
maximum power (Boost).
), a sound signal,
when the hob is