Johnson JCMV2 Manual De Instrucciones página 89

Step 3: Mount the intake grille.
Ensure that the buckles at the back
of the grille be properly seated in
the groove of the panel.
Step 4: Connect the 2 wires of the
decoration panel to the mainboard
of the unit.
Step 5: Fasten the control box lid
with 2 screws .
Step 6: Close the intake grille, and close
the 2 grille hooks.
(B)
Step 1: Remove the front grille.
1. Push both of the tabs towards the
middle simultaneously to unlock
the hook on the grille.
2. Hold the grille at a 45° angle, lift it
up slightly and detach it from the
main body.
Remove the grid screws
Grille switch
Grille screw cover
Step 2: Remove the installation covers
at the four corners by sliding them
outwards.
45°
V.3