3M DBI-SALA 8000096 Manual Del Usuario página 8

Inspection Date:
Components: Inspection:
High Capacity (HC) Inspect the HC Davit Base for cracks, dents, or deformities.
Davit Base
(Figure 2)
Inspect the entire unit for excessive corrosion.
Inspect the fastener torque and re-torque if necessary as defined by the fastener
manufacturer's specifications.
Labels (Figure 5)
Verify that all labels are securely attached and are legible (see 'Labels').
PFAS and Other Additional Personal Fall Arrest System (PFAS) equipment (harness, SRL, etc) that are
used with the HC Davit Base should be installed and inspected per the manufacturer's
Equipment
instructions.
Serial Number(s):
Model Number:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
1 Competent Person:
One who is capable of identifying existing and predictable hazards in the surroundings or working conditions which are unsanitary,
hazardous, or dangerous to employees, and who has authorization to take prompt corrective measures to eliminate them.
Table 3 – Inspection and Maintenance Log
Inspected By:
(See Section 1 for Inspection Frequency)
User
Date Purchased:
Date of First Use:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Competent
Person
1