Publicidad
Idiomas disponibles
Idiomas disponibles
GB
IRL
Repairs and modifications to the tank are not permitted.
The effect of the safety valve must not be bypassed or made inoperative.
Avoid ignition sources in the environment if you spray combustible liquids.
Do not allow the device to remain under pressure and/or exposed directly to
sunlight. Make certain the device is not heated beyond the maximum operating
temperature (→ Table 1). Protect the device from frost.
Never blow through the nozzles or valves with your mouth.
Use only MESTO spare parts and accessories.
We cannot assume any liability resulting from the use of third-party parts.
Wear suitable protective equipment when working with hazardous substances.
When pumping, always observe the piston pressure gauge to ensure the maximum
spraying pressure is not exceeded (→ Table 1 below).
Before filling, after use and before maintenance work, allow the residual pressure in
the tank to dissipate completely (→ Section "After Use", Item 1).
Scope of delivery
Tank [1] with pump [2], hose [3], instructions for use [4], spray wand [5], shut-off valve [6],
carrying strap [7]. (Fig. 1)
You will find the illustrations referred to in the text in the front fold-out pages 3 – 5 of
these instructions for use.
Technical data
Type of device
Max. filling amount
Total contents
Max. spraying pressure
Max. operating temperature
Weight when empty
Material of tank
Where device is carried
Technical residual quantity
Max. volume flow
Recoil force
Pressure change from 0 to 3 bar
Table 1
Assembly
1. Fasten the carrying strap [7] on the tank [1]. (Fig. 2)
2. Push the hose [3] into the fixture [9] and secure it with the cap nut. (Fig. 4)
3. Push the hose [3] onto the shut-off valve [6] and secure it with the cap nut. (Fig. 4)
4. Screw the spray wand [5] onto the shut-off valve [6]. (Fig. 4)
AUS
USA
PROFI 3275
5 l
8 l
1.8 kg
13
NZ
CDN
PROFI 3270
10 l
12.5 l
3 bar
40 ° C
2.8 kg
polyethylene
on the side
< 0.07 l
1 l/min
< 5 N
min. 5000 x
IND
Publicidad
