Sharp AY-X08CR Manual De Instrucciones página 12

ADJUSTING THE AIR FLOW DIRECTION
VERTICAL AIR FLOW DIRECTION
The air flow direction is automatically preset in each mode as follows for optimum
comfort:
COOL and DRY mode
FAN ONLY
(and HEAT for AY-X08CR/AY-X10CR/AY-X13CR)
HOW TO ADJUST THE AIR FLOW DIRECTION
Press the SWING button on the
remote control once.
• The vertical adjustment louvre
will change its angle continu-
ously.
Press the SWING button again
when the vertical adjustment
louvre is at the desired position.
• The louvre will stop moving within
the range shown in the diagram.
• The adjusted position will be
memorized and will be automati-
cally set to the same position
when operated the next time.
HORIZONTAL AIR FLOW DIRECTION
Hold the horizontal adjustment
louvre as shown in the diagram
and adjust the air flow direction.
CAUTION
Never attempt to adjust the vertical adjustment louvres manually.
• Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction
when the remote control is used for the adjustment.
• When the vertical adjustment louvre is positioned at the lowest position in the COOL or
DRY mode for an extended period of time, condensation may result.
mode
Adjustment range
COOL and DRY mode
The adjustment range
is narrower the SWING
range in order to pre-
vent condensation from
dripping.
E-10
Horizontal air flow
Diagonal air flow
FAN ONLY (and HEAT for
AY-X08CR/AY-X10CR/AY-
X13CR) mode
The range is wide so the
air flow can be directed
toward the floor.