Kärcher ICC 1 S D Manual Del Usuario página 30

Danger
Charge the battery only with an appropriate
charger.
Connect positive terminal cable from
the charger to the positive pole connec-
tion on the battery.
Connect negative terminal cable from
the charger to the negative pole con-
nection on the battery.
Plug in mains connector and switch on
charger.
Charge battery using lowest possible
level of charging current.
Note
When the battery is charged, first remove
the charger from the mains and then dis-
connect it from the battery.
Check engine oil level and top up, if re-
quired
Danger
Risk of burns!
Allow engine to cool down.
Wait for at least 5 minutes after switch-
ing off the engine before checking the
engine oil fill level.
Raise waste container.
Pull out the securing splint on the waste
container.
Release the left and right safety sup-
ports and secure with splint.
Unscrew the motor cover.
Pull out oil dipstick.
Wipe off oil dipstick and insert.
Pull out oil dipstick.
Read the value of the oil level.
Insert the oil dip again.
30
English
– The oil level must lie between "MIN" and
"MAX" marking.
– Add motor oil if the oil level is below the
"MIN" marking.
– Do not fill oil above the "MAX" marking.
Loosen the screw cap of the oil filling
opening.
Fill in motor oil.
Oil grade: see Technical Data
Close oil filler opening.
Wait at least 5 minutes.
Check engine oil level.
Change the motor oil and the oil filter.
Danger
Risk of burns due to hot oil!
Ready a catch bin for appr. 4 litre oil.
Allow engine to cool down.
Unscrew oil drain plug.
Loosen the screw cap of the oil filling
opening.
Drain off oil.
Unscrew the right side-panelling.
Unscrew the oil filter.
Clean the intake and sealing areas.
Coat the washer of the new oil filter with
oil before fitting it.
Fit in the new oil filter and tighten it by
hand.
Screw in the oil drain screw along with
the new washer.
Note
Tighten the oil drain screw using a torque
wrench to 25 Nm.
Fill in motor oil.
Oil grade: see Technical Data
Close oil filler opening.
Let the motor run for approx. 10 sec-
onds.
Check engine oil level.
Check dirt indicator of hydraulic filter.
Unscrew the left side-panelling.
Lock parking brake.
Engine speed adjustment - pull out 1/3
Start the motor.
Check dirt indicator of hydraulic oil filter
when the oil is warm.
Replace filter element if the indicator
has reached the red mark.
Check hydraulic oil level and refill hy-
draulic oil
Check hydraulic oil level in the looking
glass.
– The oil level must lie between "MIN" and
"MAX" marking.
– Add hydraulic oil if the oil level is below
the "MIN" marking.
Clean the filling area.
Loosen the screw cap of the oil filling
opening.
Pull out the oil filter along with the oil fil-
ter housing.