Parkside PHA 12 B2 Traduccion Del Manual De Instrucciones Originale página 38

GB MT
• to check the device immediately if it
starts to vibrate excessively.
• For safety reasons, replace worn
or damaged parts. Only use original
spare parts and accessories.
• Only use accessories recommended
by PARKSIDE. Unsuitable accessories
may cause electric shock or fire.
Preparation
WARNING! Risk of injury due to uninten-
tional start-up. Do not insert the rechargeable
battery into the device until the device is fully
prepared for use.
Control elements
Familiarise yourself with the operating elements
before using the device for the first time.
Cutting depth adjustment
• A rotary knob can be used to adjust the cut-
ting depth (1).
• The depth of cut can be adjusted to
between 0 and 2 mm.
• The best cutting depth is between 0 and
1.2 mm (green section of the scale on the
rotary knob).
Configuring the shavings
ejector
Options
There are 3 options for configuring the shav-
ings ejector:
• Ejection of shavings on both sides without
insert in the shavings ejector
• Ejection of shavings on one side with direc-
tional insert
• Extraction with dust extraction adapter
Extraction is recommended if dust is to be
expected.
Inserting the directional insert
The directional insert (14) can be inserted from
both sides.
38
1. Push the directional insert as far as it goes
into the shavings ejector (13) from the side
that you want to close off.
There are grooves in the shavings ejector to
ensure correct positioning.
Inserting the dust extraction adapter
The dust extraction adapter can be inserted
from both sides.
1. Push the dust extraction adapter (15) with
the opening pointing downwards (⊓) into
the shavings ejector (13).
2. Connect the dust extraction adapter to a
suction hose (e.g. PARKSIDE wet/dry vacu-
um).
3. Make sure that the dust extraction system
is suitable for the material to be cut. This in-
formation can be found in the operating in-
structions of the external device.
Rotating or replacing the
planer blades
WARNING! Risk of injury due to uninten-
tional start-up. Remove the rechargeable bat-
tery from the device.
CAUTION! Cutting injuries! Do not hold
the planer blade by its cutting edges.
Notes
• The blades have two cutting edges, which
can be turned around.
• Always rotate or replace the planer blades
in pairs.
• Do not attempt to sharpen the planer
blades!
• Always change the planer blades one after
the other. In this way, you can use the one
that is still installed to guide you during fit-
ting.
• For replacement planer blades, see Spare
parts and accessories, p. 43.
Dismantling the planer blade (fig. A)
1. Set the cutting depth adjustment (1) to 0.
2. Release the hexagon bolts (22) with the
open-end spanner (11).
3. Lower the planer blade guard (16) and
slide the blade holder (19) with the planer