Publicidad
Idiomas disponibles
Idiomas disponibles
FEATURES
KNOW YOUR COMPOUND MITER SAW
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
10 in. BLADE
A 10 in. blade is included with your compound miter saw. It
will cut materials up to 5-1/2 in. wide, depending upon the
angle at which the cut is being made.
15 AMP MOTOR
This saw has a powerful 15 amp motor with sufficient power
to handle tough cutting jobs. It is made with all ball bearings,
and has externally accessible brushes for ease of servicing.
BEVEL LOCK KNOB
The bevel lock knob securely locks your compound miter
saw at desired bevel angles.
BEVEL STOP ADJUSTMENT SCREWS
See Figure 2.
Bevel stop adjustment screws have been provided on each
side of the saw arm. These adjustment screws are for mak-
ing fine adjustments at 0°, 33.9°, 45° and 48°.
NOTE: Use the bevel override to locate 33.9°, 45°, and 48°
bevel angles.
BLADE WRENCH STORAGE
A blade wrench is packed with this saw. One end of the
wrench is a phillips screwdriver and the other end is a hex
key. Use the hex key end when installing or removing blade
and the phillips end when removing or loosening screws.
A storage area for the blade wrench is located behind the
miter fence.
CARRYING HANDLE
See Figure 3.
For convenience when carrying or transporting the miter
saw from one place to another, a carrying handle has been
provided. To transport, turn off and unplug the saw, then
lower the saw arm and lock it in the down position. Lock
saw arm by depressing the lock pin.
ELECTRIC BRAKE
An electric brake has been provided to quickly stop blade
rotation after the switch is released.
LASER GUIDE
For more accurate cuts, a laser guide is included with your
miter saw. When used properly, the laser guide makes
accurate, precision cutting simple and easy.
BEVEL STOP ADJUSTMENT
SCREW FOR 45
ANGLES
°
33.9º
45º
48º
BEVEL OVERRIDE
CARRYING
HANDLE
LASER GUIDE
SWITCH
MITER
LOCK KNOB
SAW ARM LOCKED IN DOWN POSITION
10
BEVEL STOP ADJUSTMENT
SCREW FOR 0
ANGLES
°
Fig. 2
LOCK
PIN
Fig. 3
Publicidad
