Tabla De Contenido - Grundfos Unilift KP 150 Instrucciones De Instalación Y Funcionamiento

English (US) Installation and operating instructions
Original installation and operating
instructions
These installation and operating instructions
describe Grundfos Unilift KP 150, KP 250 and
KP 350.
Sections 1-5 give the information necessary to
be able to unpack, install and start up the
product in a safe way.
Sections 6-10 give important information about
the product, as well as information on service,
fault finding and disposal of the product.
CONTENTS
1. Limited warranty
2. General information
2.1 Hazard statements
2.2 Notes
2.3 Overview drawing
3. Receiving the product
3.1 Inspecting the product
3.2 Scope of delivery
4. Installing the product
4.1 Pipe connection
4.2 Minimum space
4.3 Location
4.4 Adjustment of cable length for a float
switch
4.5 Check valve
4.6 Electrical connection
5. Starting up the product
5.1 Starting
6. Product introduction
6.1 Product description
6.2 Applications
6.3 Identification
6.4 Functions
6.5 Pump construction
7. Servicing the product
7.1 Cleaning the pump
7.2 Contaminated pumps
7.3 Replacement of parts
8. Fault finding the product
9. Technical data
9.1 Electrical data
9.2 Operating conditions
9.3 Storage temperature
9.4 Sound pressure level
10. Disposing of the product
4
Read this document before installing
the product. Installation and operation
must comply with local regulations
and accepted codes of good practice.
Successful operation depends on
careful attention to the procedures
described in this manual. Keep this
manual for future use.
Page
5
5
5
6
6
6
6
6
7
7
8
8
9
9
9
10
10
11
11
11
12
13
13
14
14
16
16
17
19
19
19
19
19
19