Parkside PAAS 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 32

GB MT
Spare parts/accessories
You can get spare parts and accessories from www.grizzlytools.shop
If you have issues ordering, please use the contact form. If you have any other questions,
please contact the Service Centre (see page 34).
Position instruction
manual
2,11,12,13
Troubleshooting
Problem
Device does not
start
Device works
with interruptions
Blades become
hot
Green LED (9)
fl ashing
32
Position ex-
ploded view
Name
20-22 Cutting blade with assembly tool:
Cutting blade, hex key with Phillips
screwdriver, open-end spanner
Possible cause
Battery (17) discharged
Battery (17) not inserted
On/off switch (8)/start
lever (10) not actuated
On/off switch (8)/start
lever (10) defective
Internal loose contact
On/off switch (8)/start
lever (10) defective
Blade (2) blunt
Blade (2) has nicks
Blade (2) dirty
Too much friction
Overload
Battery (17) empty
Error
Remedy
Charge the battery (see chapter "Charging
the battery")
Insert the battery (see chapter "Removing/
inserting the battery")
Switch on (see chapter "Switching on and
off")
Repair by Service Centre
Repair by Service Centre
Replace the blade (2) (see chapter "Replac-
ing the cutting blade")
Check or replace the blade (2) (see chap-
ter "Replacing the cutting blade")
Clean the blade (2) (see chapter "Cleaning")
Check fi t of gear nut (3) and screw (5)
(see chapter "Changing the cutting blade"
– Trial run)
Cut thinner or softer material
Check fi t of gear nut (3) and screw (5)
(see chapter "Changing the cutting blade"
– Trial run)
Charge the battery (see chapter "Charging
the battery")v
Contact the service centre
Order no.
91110232