Samsung MX-ST90B Manual página 15

– Make sure that the HOST is turned on, and has a music source connected to it, and the volume
is not muted.
• Wired Group Play function does not work properly:
– Turn off the system. Then, turn it back on again to activate the function.
• When a microphone is connected to the HOST and being used, the MIC sound is output to all the
connected Sound Towers in the group.
Connecting wireless Group Play mode
You can connect multiple audio systems in a wireless group play mode to create a more interesting
party environment and to produce higher sound output.
Precondition
• When connecting a Sound Tower, make sure it is within 1 m distance.
• Cannot set the mode to Group Play mode when sound tower is connected to a TV.
• Before using Group Play mode, any sound towers should be taken out of Stereo mode.

POWER
HOST
Sound Tower
Press the GROUP PLAY button on the HOST Sound Tower and wait until the "GROUP PLAY" LED

switches from blinking slowly to blinking quickly. This Sound Tower will become the Sound Tower
HOST.
※ Only BT source can be used, selecting another source will cause Group Play mode to disconnect.
※ Press and hold "GROUP PLAY" button for 5 seconds while the BT source is selected and the
Group Play LED will blink quickly immediately.
Press the GROUP PLAY button on the SUB Sound Tower, and it will begin searching for the HOST

while the "GROUP PLAY" LED blinks, and the LED will turn solid and the speaker will beep after
connecting to the HOST.
If less than 20 minutes have passed since Group Play button was pressed, refer to Step 2 to

connect additional SUB. If 20 minutes have passed since Group Play was pressed, repeat steps 1
and 2 to connect additional SUB.
• Play music on the HOST Sound Tower. Sound outputs from all the connected systems.

LED Blinks Slow(15s)
Waiting to enter
pairing mode
LED Blinks Fast(30s)
SUB Connection
available
Sound Tower
ENG - 10
Continue these
steps to
connect Sound
Towers until the
POWER
last one is
connected.
SUB 1

POWER
Last(SUB)
Sound Tower