Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
All maintenance should only be carried out by a qualified service technician.
WARNING
• Before cleaning or performing any maintenance, remove the battery from the tool. Never
disassemble the tool, battery pack or charger. For safe and proper operation, always keep
the tool and its ventilation slots clean.
• To reduce the risk of personal injury and damage, never immerse your tool, battery pack or
charger in liquid or allow a liquid to flow inside them.
Cleaning
• If there is any liquid left in the tank after spraying, drain the tank before cleaning.
• Always use only a soft, dry cloth to clean outside of the tank; never use detergent or alcohol.
• Fill the tank about one-third full with clean water. Spray until the tank has been emptied.
Make sure to direct the spray toward an area that will not be damaged by the spray solution.
• Refill and repeat the procedure with clean water. It may be necessary to rinse the tank more
than once, then drain again as directed above.
• Allow all pieces to completely dry before reinstalling parts and storing the unit.
Cleaning the Nozzle
If the nozzle becomes obstructed, use the steps
below to clear it:
• Remove the battery pack.
• Unscrew and remove the nozzle from the spray
wand.
• Push a small wire (not included) through the
cross holes to clear any debris. If necessary,
rinse the cross holes and nozzle with clean
water.
• Wipe the nozzle and cross holes with a clean
dry cloth and reinstall the nozzle.
Storage
Store indoors. Store the sprayer at room temperature in a dry, clean, well-ventilated location
that is locked and/or inaccessible to children.
8
13
Nozzle
Publicidad
