Beurer BC 81 Manual De Instrucciones página 21

6.4 Performing the blood pressure mea-
surement
Attach the cuff and maintain correct posture
throughout the measurement.
• Press the START/STOP
button to start the mea-
surement. All segments
in the LCD Display will
appear briefly.
Measurement will begin after
about three seconds.
The measurement is taken during the inflation
phase.
• You can cancel the measurement at any time
by pressing the START/STOP button.
As soon as a pulse is
detected, the pulse sym-
bol is displayed.
• The systolic pressure,
diastolic pressure,
and pulse rate are dis-
played.
•
• Select a user memory number by pressing the
!
OK
• Press the START/STOP button to switch off
• The device will shut off after about three min-
• Wait at least 5 minutes before taking another
21
appears if the measurement was not per-
formed properly. Refer to the chapter on error
messages/troubleshooting and then repeat the
measurement.
M1 or M2 button. If you do not select a user
memory, the measurement is stored in the
most recently used user memory. The active
user memory symbol M1 or M2 appears in the
LCD Display.
the wrist blood pressure monitor. The mea-
surement is then stored in the selected user
memory.
utes if no buttons are pressed. The last mea-
surement is still stored in the selected or most
recently used user memory.
measurement.