Holmatro ICU 05 Serie Manual página 36

EN
Possible cause
The deadman's handle is faulty.
7.8 Poor cutting performance
/i
Possible cause
Check the tightening torque of the cutter bolt
The blades are damaged.
8 Maintenance
8.1 General
For standard installation instructions, refer to the Service & Support section of the Holmatro website.
Meticulous maintenance of the equipment preserves the operational safety and extends the life of the
equipment.
Refer to the maintenance manual in the service set.
WARNING
When performing maintenance activities, always comply with the relevant safety regulations.
Wear the prescribed personal protection equipment.
8.1.1 Dangerous substances
WARNING
Used or leaked fluids, and any other products consumed during the activities, must be
collected and disposed of in a environmentally responsible way.
8.2 Maintenance materials
/i
Application
Steel parts
Hydraulic couplers
Blades
Hinge pins
Long-term preservation
Contact the Holmatro dealer for information on spare parts.
36
Type of maintenance material
WD-40 preservative oil
Molykote BR2 grease
Teflon lubricating oil
Tectyl ML from Valvoline
916.000.905_002
Solution
Have it repaired by a Holmatro Certified
Technician.
Solution
It must be 50 Nm.
Have them replaced by a Holmatro Certified
Technician.
Amount
As required
As required
As required
As required
ICU05/10