Holmatro HWC Serie Manual página 24

EN
1.5.2 Life span and workability
The life span and workability of the product strongly depends on a numbers of circumstances. Usage
intensity and the geometry and type of material of the parts that need to be cut are examples of these
circumstances. When in doubt about the workability or life span of this product, contact Holmatro in any
event.
1.6 Qualified personnel
The system may only be operated by people trained in its use. Always obey local legislation, safety and
environmental regulations. Repair work may only be performed by a Holmatro Certified Technician.
1.7 Guarantee
Refer to the general terms and conditions of sale for the guarantee conditions, available from your
Holmatro dealer on request.
Holmatro draws your attention to the fact that every guarantee on your piece of equipment or system
will lapse and that you must indemnify Holmatro against any possible product liability and responsibility
if:
• service and maintenance are not carried out strictly in accordance with the instructions, repairs are
not performed by a Holmatro Certified Technician or are performed without prior written consent;
• self-made changes, structural changes, deactivation of safety devices, injudicious adjustment of
hydraulic valves and faulty repairs have been carried out;
• non-genuine Holmatro parts or lubricants other than the types prescribed are used;
• the piece of equipment or the system is used injudiciously, through errors of operation, improperly,
negligently or not in accordance with its nature and/or purpose.
1.8 Declaration of Conformity
The equipment is CE certified. It means that the equipment complies with the essential requirements
concerning safety. The original Declaration of Conformity is supplied with the equipment.
The standards and directives that have been taken into consideration in the design are listed in
section Technical Specifications in this document.
2 Safety regulations
2.1 Explanation of the symbols used in this manual
In the rest of the user manual the symbols below are used to indicate possible dangers.
/i
DANGER or WARNING
Symbol: warning of unsafe working conditions if the instructions are not followed.
This symbol is displayed with all safety regulations related to situations that are life-
threatening (danger), present a danger of personal injury (warning), or both.
/i
Caution
Symbol: warning of danger of operational safety of the product or the system.
This symbol is displayed in the user manual with all regulations related to preventing
damage to the product or the system.
24 916.219.133_003 HWC/HCC