Husqvarna 565 Manual Del Usuario página 12

• Chain oil hole and hole for chain tensioner. The bar
must be matched to the chain saw design.
Saw chain
• Chain pitch (inches)
D
• Drive link width (mm/inches)
• Number of drive links.
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
WARNING: Always wear protective gloves
when you assemble the saw chain.
WARNING: The start/stop switch
automatically returns to run position. In order
to prevent unintentional starting, the spark
12
D
PITCH =
2
Assembly
Cutting equipment designed to reduce kickback
The only way to avoid kickback is to make sure that the
kickback zone of the bar never touches anything. By
using cutting equipment with "built-in" kickback reduction
and keeping the chain sharp and wellmaintained you
can reduce the effects of kickback.
Guide bar
The smaller the tip radius the lower the chance of
kickback.
Saw chain
A chain is made up of a number of links, which are
available in standard and low-kickback versions.
WARNING: No saw chain design eliminates
the danger of kickback.
plug cap must be removed from the spark
plug when assembling, checking and/or
performing maintenance.
359 - 002 -