Husqvarna 565 Manual Del Usuario página 38

Guide bar mount
Recommended bar
lengths, inch/cm
Pitch, inch/mm
Thickness of drive links,
inch/mm
Type of drive sprocket/
number of teeth
Saw chain speed at 133%
of maximum engine power
speed, ft/s / m/s.
Recommended cutting equipment
A specific chainsaw model has to be evaluated with the
cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2012 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
Z62.1-15 (Chainsaws) and (Chainsaw kickback).
Chainsaw models Husqvarna 565, 572XP and 572XPG
met the safety requirements in ANSI B175.1-2012 and
Canadian Standards Association Z62.1-15 (Chainsaws)
and (Chainsaw kickback), when equipped with the below
listed saw chain and guide bar combination(s).
Note: Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
Guide bar
Length, inch Pitch, inch
15 3/8
16
18
20
24
28
Filing equipment and filing angles
Using Husqvarna file gauge will give you the correct
filing angles. We recommend you to always use a
Husqvarna file gauge to restore the sharpness of the
38
565
Large
15-28"/38-71
3/8 /9,52
0,058/1,5
Rim/7
90.2/27,5
Accessories
Gauge, inch
0.058
572XP
Large
15-28"/38-71
3/8 /9,52
0,058/1,5
Rim/7
96.1/29,3
We recommend only to use the listed guide bar and saw
chain combination(s).
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is defined by the
number of teeth (for example 10T). For solid guide bars
the nose radius is defined by the size of the nose radius.
For a given guide bar length, you may use a guide bar
with smaller nose radius than listed.
Saw chain
Max. nose radius Type
11T Husqvarna H42
Husqvarna C85
34 mm
saw chain. The part numbers are given in the table
below.
572XPG
Large
15-28"/38-71
3/8 /9,52
0,058/1,5
Rim/7
96.1/29,3
Length, drive
links (no.)
56
60
68
72
84
92
359 - 002 -