Descargar Imprimir esta página

Uline H-10089 Instrucciones De Montaje página 2

Ocultar thumbs Ver también para H-10089:

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: Count and inspect all pieces before
disposing of cartons or packing materials.
CAUTION! Adjustable table frame is heavy and
care should be used when moving it during
assembly.
1.
Place adjustable table frame with lifting columns (3)
on a clean, smooth, non-marring surface to prevent
scratching.
NOTE: Lifting columns are pre-installed to
adjustable table frame and are folded down
toward center of adjustable table frame for
shipping.
2. Unfold the lifting columns to an upright position.
(See Figure 1)
Figure 1
Lifting
Column
3. Insert top support bracket (6) into outside of adjustable
table frame (3). (See Figure 2) Repeat this step on the
opposite end.
NOTE: Steel lip with three holes on top support
bracket should be facing down.
Figure 2
6
PAGE 2 OF 23
ASSEMBLY
3
3
4. Insert two M6 x 33 mm machine screws (11) into
holes on end of adjustable table frame to secure
top support bracket (6). Lightly tighten using 5 mm
hex wrench (17). Lightly tighten two pre-installed
M6 x 33 mm machine screws (11) to secure lifting
column. (See Figure 3) Repeat this step on the
opposite side.
NOTE: To prevent alignment issues during this
step, do not tighten completely until all four
machine screws are inserted.
Figure 3
11
5. Attach foot (5) to lifting column using four M6 x 15 mm
machine screws (12). Tighten using 4 mm hex wrench (16).
Repeat on opposite side. (See Figure 4)
Lifting
Column
17
16
5
12
0123 IH-10089
Figure 4

Publicidad

loading