Uline H-10089 Instrucciones De Montaje página 3

6. Place adjustable return frame with lifting column (4)
on a clean, smooth, non-marring surface to prevent
scratching.
NOTE: Lifting column is pre-installed to
adjustable return frame and is folded down
toward center of adjustable return frame for
shipping.
7. Unfold lifting column to an upright position.
(See Figure 5)
Figure 5
8. Insert top support bracket (6) into outside of
adjustable return frame (4). (See Figure 6)
NOTE: Steel lip with three holes on top support
bracket should be facing down.
Figure 6
4
9. Insert two M6 x 33 mm machine screws (11) into
holes on end of adjustable return frame to secure
top support bracket and lightly tighten using 5 mm
hex wrench (17). Lightly tighten two pre-installed
M6 x 33 mm machine screws (11) to secure lifting
column. (See Figure 6)
PAGE 3 OF 23
ASSEMBLY CONTINUED
Lifting
Column
4
11
17
10. Attach foot (5) to lifting column using four M6 x 15 mm
machine screws (12). Tighten using 4 mm hex
wrench (16). (See Figure 7)
Figure 7
11. Attach adjustable return frame to adjustable table
frame using two M6 x 12 mm machine screws (14).
Tighten using 5 mm hex wrench (17). (See Figure 8)
Figure 8
Adjustable
Return Frame
6
12. Connect the power cord from the adjustable return
frame (4) to the adjustable table frame (3).
16
12
5
Adjustable
Table Frame
14
17
0123 IH-10089