Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROLS
Up
Down
Button
Button
NOTE: The desk must be initialized prior to
first use.
• To initialize, press and hold the down button on the
handset until the desk reaches its lowest height,
slightly raises and stops.
• Release the down button. The desk is now ready to use.
NOTE: The desk may need to be reset from time
to time to work properly. Unplug the power cord
for 20 seconds, plug back in and follow the
initialization process to reset desk.
CAUTION! Ensure there are no obstacles in the
desk's height adjustment path, and the desk is
not touching any walls.
CAUTION! Ensure all cords are at the
appropriate length to accommodate changes
in height.
HEIGHT ADJUSTMENT
• Press the up button to raise the desktop.
• Press the down button to lower the desktop.
• Release button to stop movement.
CAUTION! To avoid overheating, do not move
the desk up and down continuously for over
two minutes within any 20 minute period. If the
heater overheats,
handset. Stop using the desk for 20 minutes
and let it cool down.
PAGE 6 OF 23
24.5
Setting
Display
Button
OH
will be displayed on the
OPERATION
Four Preset
Position Buttons
PROGRAMMING PRESET HEIGHT
• Use up and down buttons to move desk to the
desired position.
• Press and hold the setting button and one of the four
preset position buttons simultaneously.
• The handset will display
each preset when complete.
• Up to four presets can be programmed.
PROGRAMMING HEIGHT LIMITS
NOTE: Desk is equipped with a height limit function.
This function allows upper and lower height limits
to be programmed. This can be used to prevent
collisions with objects above and below the desk,
such as file pedestals and overhead cabinets.
• Use up and down buttons to move desk to the
desired upper height limit. Press and hold the setting
button and up button simultaneously. The upper
limit is set when
same buttons again. The upper limit is cancelled
HCL
when
• Repeat the process to set the lower limit. The lower
limit is set when
cancelled when
• Always program height limits before programming
preset heights.
SWITCHING BETWEEN INCHES AND CENTIMETERS
• Press the setting button for seven seconds until
is displayed, and then press the first preset position
button. The default unit of measurement will be
displayed. Press the up and down button to change
between inches and centimeters.
1CF
2CF
,
,
HI
is displayed. To cancel, press the
is displayed.
LO
is displayed. The lower limit is
LCL
is displayed.
USB Charger
3CF
4CF
and
for
SET
0123 IH-10089
Publicidad
