DeWalt DWV010-BR Manual De Instrucciones página 34

2. Line up filter threads (T) to vacuum head threads and using
moderate force, turn filter clockwise until tight.
NOTE: Use care to not damage filter material.
3. Place the vacuum head (C) onto the container and secure it by
closing the canister latches (D).
Cleaning
WARNING: Blow dirt and dust out of all air vents with dry air at
least once a week. Wear proper ANSI Z87.1 (CAN/CSA Z94.3) eye
protection and proper NIOSH/OSHA/MSHA respiratory protection
when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the motor.
Storage (Fig. 1)
1. Empty the canister, refer to To Empty Canister under
Operation.
2. Clean the vacuum inside and outside.
3. Clean or replace filters, refer to Filters.
4. Store the suction hose and the power cord as shown in the
illustration. Secure hose with the hose strap (K) on the back
of the vacuum. Place the unit in a dry room and secure it from
unauthorized use.
Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
e
accessories with this tool could be hazardous. To reduce the risk
of injury, only D WALT recommended accessories should be used
e
with this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center.
OPTIONAL ACCESSORIES
HEPA filter: Captures 99.97% of all
particles greater than or equal to 0.3
DWV9330
microns. Required when picking up lead
paint debris.
5"–6" (127–152 mm)
DWE46100
Cutting/tuckpointing shroud
5"–6" (127–152 mm)
DWE46101
Cutting/tuckpointing shroud kit
5" (127 mm) Cutting/tuckpointing
DWE46150
shroud
5" (127 mm) Cutting/tuckpointing
DWE46151
shroud kit
DWE46170 7" (178 mm) surface grinding shroud
DWH050K DWH050 drilling dust extraction system
32