Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFIC SAFETY RULES
ALLOW THE MOTOR TO COME UP TO FULL SPEED
before starting a cut to avoid binding or stalling
DO NOT FEED THE MATERIAL TOO QUICKLY. Do not
force the workpiece against the blade.
DO NOT REMOVE JAMMED CUTOFF PIECES until
blade has stopped.
BEFORE CHANGING THE SETUP, REMOVING
COVERS, GUARDS OR BLADES, unplug the saw and re-
move the switch key.
IF THE POWER SUPPLY CORD IS DAMAGED, it must
be replaced only by the manufacturer or by an authorized
service center to avoid risk.
ALWAYS STAY ALERT! Do not allow familiarity (gained
from frequent use of your saw) to cause a careless mis-
take. ALWAYS REMEMBER that a careless fraction of
a second is sufficient to inflict severe injury
MAKE SURE THE WORK AREA HAS AMPLE LIGHT-
ING to see the work and that no obstructions will inter-
fere with safe operation BEFORE performing any work
using your saw.
ALWAYS TURN OFF THE SAW before disconnecting it
to avoid accidental starting when reconnecting to power
supply. NEVER leave the saw unattended while connected
to a power source.
CALIFORNIA PROPOSITION 65
WARNING:
This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities
may contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other
reproductive harm. Wash hands after handling.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products and,
• arsenic and chromium from chemically-treated lumber.
Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce
your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are
specially designed to filter out microscopic particles.
THIS TOOL should have the following markings:
a) Wear eye protection.
b) Do not remove jammed cutoff pieces until blade has
stopped.
c) Maintain proper adjustment of blade tension, blade
guides, and thrust bearings.
d) Adjust upper guide to just clear workpiece.
e) Hold workpiece firmly against table.
HOLD THE WORKPIECE firmly against the saw table.
TO AVOID ACCIDENTAL BLADE CONTACT, minimize
blade breakage, and provide maximum blade support,
always adjust the blade guide assembly to just clear the
workpiece.
THE BLADE GUIDES HAVE BEEN PRESET AT THE
FACTORY. These settings are functional for some ap-
plications. We recommend that you check and adjust
blade guide settings before first use of your saw. Refer to
"Adjusting thrust bearings, blade guide support, and
blade guides" procedures explained in the Adjustments
section of this operator's manual.
BEFORE STARTING THE SAW, make sure the mobile
stand is level and in the locked position.
SAVE THESE INSTRUCTIONS. Refer to them
frequently and use to instruct other users. If you loan
someone this tool, loan them these instructions also.
5
Publicidad
