Kodak P460 Guia Del Usuario página 16

Clean the Image Sensor
1. Clean the scanner's outer casing first.
C a l i b r a t e t h e S c a n n e r
If the scanned picture looks fuzzy or there are strange stripes on it, the scanner may need calibrating in order for the sensor to
resume its original precision.
Follow the instructions beginning on page 15 to clean the roller and the image sensor, and then follow the instruction in "Initial
Setup" on page 7 to prepare the scanner for scanning.
S t o r i n g t h e S c a n n e r
If the scanner will not be used for a prolonged period of time, follow the instructions below to store the scanner for future use.
1. Disconnect the scanner from power supply.
2. Place the scanner and power adapter in a box or bag to keep them from accumulating dust.
3. Place it in a cool and dry place, inaccessible to small children.
4. After long-term storage, it is recommended that you clean and calibrate the scanner before use.
16 Customer Support: http://www.pandigital.net/kodaksupport
All manuals and user guides at all-guides.com
When the cleaning process is completed, the cleaning sheet will be ejected from the feed slot, and
the power indicator light will go off.
5. Remove the cleaning sheet. Store it in a safe place and protect it from dust.
2. With the scanner powered off and disconnected from the power supply, insert the
sensor cleaning swab into one end of the output slot.
 Make sure that there is no visible dust on the swab before inserting it into the
output slot
3. Gently slide the sensor cleaning swab back and forth from one end of the output slot
to the other five or six times consecutively.
CAUTION: Do not apply too much force on the swab.
4. Slide the sensor cleaning swab to the left end of the output slot, and then remove it
from the slot.
 Store it in a safe place and protect it from dust.
Insert the calibration card as shown.
The scanner will scan the pattern on the calibration card and perform calibration to the sensor inside
automatically.
 Make sure that the calibration card is inserted in the correct direction. Otherwise the calibration
won't work.