Kärcher CV 38/2 Manual De Instrucciones página 12

CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
Care and maintenance
DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
Maintenance intervals
Daily
 Clean the brush roller.
Cleaning the brush roller
 Dismount the brush cover if necessary:
Turn the turn-lock fasteners by 90° and
remove the brush cover.
 Cut hair and threads that have got
wound on the brush roller using a pair of
scissors or just remove them.
Replacing the filter bag
 Unlock and remove the filter cover.
Illustration
 Turn the locking mechanism of the filter
bag towards the right. Close, remove,
and dispose of the filter bag.
Illustration
 Insert a new filter bag and turn the lock-
ing mechanism of the filter bag towards
the left.
 Insert and lock filter cover.
Replace exhaust filter
 Unlock and remove the filter cover.
 Push the locking mechanism of the filter
casing upwards and remove the filter
casing.
 Remove the exhaust filter from the filter
housing.
 Insert new exhaust filter into filter hous-
ing.
 Insert and click the filter housing into its
place.
 Insert and lock filter cover.
12
Storage
Replace motor protection filter
 Unlock and remove the filter cover.
 Push the locking mechanism of the mo-
tor protection filter upwards. Remove
and dispose of the motor protection fil-
ter.
 Install and lock the new motor protec-
tion filter.
 Insert and lock filter cover.
Replacing the brush roller
 Dismount the side part by means of a
coin.
 Pull out the brush roller and dispose of.
 Insert a new brush roller.
 Reinstall side part.
Troubleshooting
DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
Remove blockings
Suction pipe/suction hose
Illustration
Suction hose on the brush head
Illustration
Brush roller/brush head
Illustration
Note: If necessary, dismount brush cover
(refer to "Cleaning of the brush roller").
Motor does not run
– No electrical voltage.
 Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
– Thermostat switched off the motor be-
cause of overheating
 Replace blocked filters or remove
blockages from the suction hose.
The unit is operational again after it has
cooled down.
– 3
EN