Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guidesbox.com
CONNECTION FOR MODELS LWFR7100S,
LWFR7200S, LWFR7600S, LWER5000S
GAS POWER SUPPLY
GAS L.P. CYLINDER INSTALLATION IMPORTANT:· This product is prepared to work with LP
gas (Liquefied Petroleum Gas).
· Before installation make sure that the local gas distribution conditions (nature and gas
pressure) and the technical specifications of this stove are compatible.
· The technical specifications for this stove are found on the identification label on the back of
this product.
· The area where the stove is going to be installed must take into account the ventilation
conditions required by local regulations.
· This stove is set to be installed from 0 to 3800 meters above sea level
· The gas hose must not come into contact with the back of the stove.
· Flexible PVC hose (with polyester reinforcement, 3/8 inch) for gas must withstand
temperatures
above 120 ° C and must be approved by local regulations and within the period of validity.
· If your Stove has a power cord, it must not come into contact with the back of the stove.
Tools and parts required to install your stove with gas cylinder L.P.
NOTE: These tools and parts are not supplied with your stove.
1. Gas cylinder regulating valve in accordance with local regulations.
Pressure 275 kPa (280 mmca) and outlet for gas hose. Confirm the validity date.
2. Metal clamp with screw.
3. Flexible PVC hose (with polyester reinforcement, 3/8 inch) of gas.
It must withstand temperatures exceeding 120 degrees Celsius and must be approved by local
regulations and within the period of validity.
Hose for domestic use only and resistant to abrasion and chemicals.
The hose must be replaced before the expiration date indicated by the supplier or at least
before 5 years of use.
The hose must not cross the back of the oven after product installation.
The hose must be protected from direct sunlight.
The maximum hose length should be 1.25 m.
4. Screwdriver.
Proper installation procedure
1. Place one of the metal clamps on one end of the
hose and connect this end of the hose to the gas
outlet located on the back of the stove (fig. 1).
35
In some European factories the letter "W" of the part code mentioned herein will be automatically
17-Sep-2019 13:32:01 EDT | RELEASED
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Publicidad
