Kenmore Elite BU1018 Manual De Uso Y Cuidado página 16

WARNING
Always unplug power cord from electrical
outlet before performing maintenance to
the vacuum cleaner.
DUST BAG STYLE O
TO REMOVE DUST BAG
1. Pull on the
dust bag cover
latch to remove
Dust Bag
dust bag cover.
Cover
Latch
NOTE: Do not
pull on the dust
bag.
3. Dispose the used dust bag carefully into
a plastic bag and tie or seal it to prevent
dust escape. Do not reuse dust bag.
Bag Saftey
Stop
Dust Bag
Holder
Motor
Safety
Filter
CAUTION
NEVER REUSE A DUST BAG. Very fine
materials, such as carpet freshener, face
powder, fine dust, plaster, soot, etc. can
clog the bag and cause it to burst before
it is full. Change bag more often when
vacuuming these materials.
CHANGING DUST BAG
2. Grasp the dust
bag collar by both
sides, (not the tab,)
and pull gently,
carefully removing
the dust bag from
the dust bag holder.
NOTE: Check
the dust bag
holder and
the motor
safety filter
for dirt or
clogs.
- 16 -
TO REPLACE DUST BAG
1. Fold the
Dust
safety seal tab
Bag
on the new
dust bag away
from the
opening that
fits on the dust
bag holder.
3. Tuck the bag into
the dust bag
chamber. Be sure all
sides of the dust
bag are completely
within bag cavity
prior to closing the
bag cover.
4. Place the tab on
the dust bag cover in the slot on the
vacuum cleaner.
Slot
5. Press the dust
bag cover into
place. You will
hear a distinct
snap when cover is
securely closed.
Check to see that the dust bag is fully
placed in the bag chamber.
NOTE: If bag is not installed or not
installed properly the bag safety stop
prevents the door from closing.
Safety
Seal Tab
2. Push dust bag
collar opening
completely over the
dust bag holder as
far as it will go.
Tab