Care and maintenance
To lubricate the slides of the gliding rack
46 English
DOB30x977Dx_AA_DG68-01313A-01_EN+MES+CFR.indb 46
DOB30x977Dx_AA_DG68-01313A-01_EN+MES+CFR.indb 46
1.
Remove the rack from the oven. See
removing the gliding rack in the Using
the gliding rack section on page 35.
2.
Fully extend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy cleanup.
If there is debris in the slide tracks,
3.
wipe it away using a paper towel. (Any
graphite lubricant wiped away must be
replaced - See steps 4 through 7.
4.
Shake the graphite lubricant before
opening it. Starting with the left (front
and back) slide mechanism of the rack,
place four (4) small drops of lubricant
on the two (2) bottom tracks of the
slide close to the bearing carriers.
5.
6.
7.
8.
•
Oven door
•
Don't hand
Don't hand
clean the
clean the
oven door
oven door
gasket.
gasket.
You may
You may
hand clean
hand clean
the door.
the door.
•
Repeat for the right (front and back)
slide mechanism of the rack.
Open and close the rack several times
to distribute the lubricant.
Replace the cap on the lubricant and
shake it again. Turn the rack over and
repeat steps 3, 4, 5, and 6.
Close the rack, turn the rack right-
side-up, and then place in oven. See
Installing the Gliding rack on page 35.
NOTE
Do not spray the gliding rack with
cooking spray or other lubricant sprays.
Use soap and water to thoroughly
clean the top, sides, and front of the
oven door. Rinse well. You may use a
glass cleaner on the outside glass of
the oven door. DO NOT immerse the
door in water. DO NOT spray or allow
water or the glass cleaner to enter the
door vents. DO NOT use oven cleaners,
cleaning powders, or any harsh
abrasive cleaning materials on the
outside of the oven door.
DO NOT clean the oven door gasket.
The oven door gasket is made of a
woven material which is essential for a
good seal. Care should be taken not to
rub, damage, or remove this gasket.
2023-03-14 오전 10:30:42
2023-03-14 오전 10:30:42