Sauder Hammond Serie Instrucciones De Montaje página 12

Step 6
å
Fasten the other EXTENSION RAIL (3) to the RIGHT
UPRIGHT (F). Use three 5/8" FLAT HEAD SCREWS (31).
å
NOTE: For the EXTENSION RAIL, turn a SCREW into the
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other
holes that lines up with the holes in the RIGHT UPRIGHT.
Turn a SCREW into these holes.
BLACK 5/8" FLAT HEAD SCREW
(3 used in this step)
Closed end
Page 12
Use these holes.
31
3
www.sauder.com/service
3
Closed end
Molding
F
430786