Sauder Hammond Serie Instrucciones De Montaje página 15

Step 9
å
Fasten the other two LONG EXTENSION RAILS (1) to the
RIGHT END (D). Use six 5/8" FLAT HEAD SCREWS (31).
å
NOTE: For each LONG EXTENSION RAIL, turn a SCREW
into the hole shown in the diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other
holes that lines up with the holes in the RIGHT END. Turn a
SCREW into these holes.
5/8" FLAT HEAD SCREW
(6 used in this step)
Closed end
430786
Use these holes.
31
1
www.sauder.com/service
1
Closed end
1
D
Molding
Page 15