Sauder Hammond Serie Instrucciones De Montaje página 8

Step 2 Step
å
Separate the EXTENSION SLIDES (4) from the EXTENSION RAILS (3) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten an EXTENSION RAIL (3) to the LEFT UPRIGHT (E). Use three 5/8" FLAT HEAD SCREWS (31).
å
NOTE: For the EXTENSION RAIL, turn a SCREW into the hole shown in the diagram. Then, slide the inner cartridge of
the EXTENSION RAIL in to find the other holes that lines up with the holes in the LEFT UPRIGHT. Turn a SCREW into
these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the KEYBOARD SHELF.
4
Push the black lever and pull
the SLIDE from the RAIL.
BLACK 5/8" FLAT HEAD SCREW
(3 used in this step)
Molding
Page 8
31
3
E
www.sauder.com/service
3
Use these holes.
Closed end
7
Closed end
430786