Sauder Hammond Serie Instrucciones De Montaje página 32

Step 26
1
1/2" FLAT HEAD SCREW
(12 used in this step)
2
M
å
Fasten the LONG EXTENSION SLIDES (2) to the DRAWER
SIDES (M and N). Use six 1/2" FLAT HEAD SCREWS (33).
Use the exact holes shown in the upper view.
3
N
Q
å
Slide the DRAWER BOTTOM (P) into the grooves in the
DRAWER SIDES (M and N) and DRAWER BACK (Q).
Page 32
2
33
Open end
2
N
These
holes
must be
here.
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the grooves.
P
M
www.sauder.com/service
2
(16 used)
9
28
M
å
Insert eight SMALL WOOD DOWELS (9) into the DRAWER
SIDES (M and N) and DRAWER BACK (Q) as shown.
å
Fasten the DRAWER SIDES (M and N) to the DRAWER
BACK (Q). Use four 1-3/8" FLAT HEAD SCREWS (28).
å
NOTE: Be sure the WOOD DOWELS in the DRAWER
BACK inserts into the holes in the DRAWER SIDES.
4
M
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Fasten the DRAWER FRONT (O) to the DRAWER
SIDES (M and N). Tighten four HIDDEN CAMS.
å
NOTE: Be sure the WOOD DOWELS in the DRAWER
SIDES insert into the holes in the DRAWER FRONT.
å
Fasten a KNOB SET (11) to the DRAWER FRONT (O).
Use a 1/2" MACHINE SCREW (35).
å
Repeat this step for the other large drawer.
28
1-3/8" FLAT HEAD SCREW
(8 used in this step)
N
Q
Groove
1/2" MACHINE SCREW
(2 used in this step)
N
O
430786
35
11