Sauder Manhattan Gate Serie Instrucciones De Montaje página 8

Step 2
å
Separate the EXTENSION SLIDES (6) from the EXTENSION RAILS (5) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten one EXTENSION RAIL (5) to the RIGHT UPRIGHT (E). Use three 3/8" PAN HEAD SCREWS (21) through the
exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the UPRIGHT. Turn a SCREW
into each hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Fasten one of the CABINET LEFT RAILS (2) to the RIGHT UPRIGHT (E).
Use three 1/2" FLAT HEAD SCREWS (22).
6
Slide the lever and pull the SLIDE from the RAIL.
Roller end
1/2" FLAT HEAD SCREW
(3 used for the CABINET RAIL)
Page 8
Open end
2
R R
22
www.sauder.com/service
3/8" PAN HEAD SCREW
(3 used for the EXTENSION RAILS)
5
5
2
E
7
21
Open end
Roller end
429254