Sauder Cannery Bridge Serie Instrucciones De Montaje página 10

Step 4
å
Separate the SHORT EXTENSION SLIDES (2) from the SHORT EXTENSION RAILS (1) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten two SHORT EXTENSION RAILS (1) to the LEFT END (A). Use six 3/8" FLAT HEAD SCREWS (22).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the LEFT END. Turn a
SCREW into these holes.
å
NOTE: The SHORT EXTENSION SLIDES will be used later for the SMALL DRAWERS.
2
Push the black lever and pull the SLIDE from the RAIL.
Open end
Page 10
1
1
www.sauder.com/service
A
7
1
22
3/8" FLAT HEAD SCREW
(6 used in this step)
429556