Sauder Cannery Bridge Serie Instrucciones De Montaje página 27

Step 21
å
Fasten a LONG EXTENSION RAIL (3) to the RIGHT END (B). Use four 3/8" FLAT HEAD SCREWS (22).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the RIGHT END. Turn a
SCREW into these holes.
3/8" FLAT HEAD SCREW
(4 used in this step)
429556
22
www.sauder.com/service
B
3
Open end
Page 27