Sauder Cannery Bridge Serie Instrucciones De Montaje página 21

Step 15
å
Fasten two SHORT EXTENSION RAILS (1) to the RIGHT UPRIGHT (D). Use six 3/8" FLAT HEAD SCREWS (22).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the RIGHT UPRIGHT. Turn a
SCREW into these holes.
Open end
429556
1
1
D
www.sauder.com/service
22
3/8" FLAT HEAD SCREW
(6 used in this step)
Page 21