Sauder Cannery Bridge Serie Instrucciones De Montaje página 11

Step 5
å
Separate the LONG EXTENSION SLIDES (4) from the LONG EXTENSION RAILS (3) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten a LONG EXTENSION RAIL (3) to the LEFT END (A). Use four 3/8" FLAT HEAD SCREWS (22).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the LEFT END. Turn a
SCREW into these holes.
å
NOTE: The LONG EXTENSION SLIDES will be used later for the LARGE DRAWERS.
4
Push the black lever and pull the SLIDE from the RAIL.
Open end
429556
A
3
www.sauder.com/service
7
3
22
3/8" FLAT HEAD SCREW
(4 used in this step)
Page 11