Sauder Cannery Bridge Serie Instrucciones De Montaje página 16

Step 10
å
Fasten a LONG EXTENSION RAIL (3) to the LEFT UPRIGHT (C). Use four 3/8" FLAT HEAD SCREWS (22).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the LEFT UPRIGHT. Turn a
SCREW into these holes.
3/8" FLAT HEAD SCREW
(4 used in this step)
Page 16
22
www.sauder.com/service
C
3
Open end
429556