Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
Maintenance and
cleaning
Remove the mains plug before car-
rying out any adjustments, mainte-
nance or repair work.
Have any work on the device
that is not described in this
instruction guide performed
by a professional. Only use
original parts. Allow the
device to cool off before per-
forming any maintenance or
cleaning. There is a danger of
burns!
Always check the device before using it
for obvious defects such as loose, worn or
damaged parts, correct the positioning of
screws or other parts. Examine the grind-
ing disc in particular (
the damaged parts.
Cleaning
Do not use any cleaning agents or
solvents. Chemical substances may
attack the plastic parts of the de-
vice. Never clean the device under
running water.
• Thoroughly clean the device after every
use.
Clean the ventilation openings (
and the surface of the device with a
soft brush, a paint brush or cloth.
Replacing the grinding
disc
Information on replacement:
• Never operate the device without
a viewing guard (
30
17). Exchange
20)
18).
• Ensure that the rotation speed
stated on the grinding disc
17) is the same or higher
(
than the nominal rotation speed
of the device. Ensure that the disc
dimensions match those of the
device.
• Only use grinding discs in perfect
working order (sound test).
• Only use grinding discs with a
locating hole of Ø 22 mm.Never
re-drill a locating hole which is
too small for the grinding disc to
make it larger.
• Never use separate bushings or
adapters in order to make grind-
ing discs with a hole that is too
large fi t the device.
• Do not use any saw blades.
• Always reassemble the device
completely after replacing the
grinding disc.
Switch off the device and unplug
the mains plug.
Allow the device to cool down.
Use protective gloves when working
with grinding discs.
1. Loosen the handgrip (4).
2. Unscrew the 3 mounting screws to the
grinding disc cover (5).
3. Remove the grinding disc cover (3).
4. Unscrew the grinding disc nuts (17a)
by hand.
5. Remove the grinding disc from the
holder (17).
6. Place the new grinding disc onto the
holder and manually screw on the
grinding disc nut.
7. Screw the grinding disc cover (3) back
on.
Publicidad
