Ca-Mi New Askir 118 Basic Manual De Instrucciones página 21

WARNING: Ensure that the filter is fitted with the Arrows at the patient side.
WARNING: The power supply cable plug is the element of separation from the electrical mains system: even if the units equipped
with a special on / off switch button, the power supply plug must be kept accessible once the device is in use so as to allow a
further method of disconnection from the mains supply system.
A pressure sensor fitted in the device allows decreasing the motor revolutions [in the absence of suction] safeguarding the internal
battery life. The motor will resume full speed only when the operator carries out the body fluid aspiration process (with the
adjustment knob set to +).
PROXIMITY FUNCTIONS:

Pressing the "Proximity" (Lights BLUE LED) is activated on / off the motor by an infrared proximity sensor that detects the
presence of the operator's hand from a few inches away. This allows the operator to use the device without touching or focus
on pressing the button.

The on / off button is also active with the function of proximity inserted and can be used as an alternative.
 To remove the "Proximity" you have to re-press the button.
The "Proximity" is retained, or if it was active before power off, then on again to return to this, but if it was not active will remain
disabled. The function set to power down the card after 20 minutes after turning off the engine if it is not then on again.
The unwanted approach of the hand to the Proximity sensors causes the device to switch off. To reactivate the
function, place the hand close to the sensors.
NOTE: It is up to the end user to activate or deactivate the Proximity sensor. With the Function off, the device is activated/deactivated
by pressing the ON/OFF key.
NEVER USE THE DEVICE WITHOUT JAR AND / OR PROTECTION FILTER
21
GB