Ca-Mi New Askir 118 Basic Manual De Instrucciones página 22

GB
Operation using cigarette lighter DC 12V

Connect the device's external plug 12V to the ligther plug with the cigarette lighter cable. Check the battery power status of
the vehicle before the cigarette lighter cable. Press the switch to start suction

Press the switch to the I position to turn it on.
WARNING: Only use the originally supplied or recommended replacement cigarette ligther cables (view the chapter
"Important Safety Rules"). If the device is used inside a vehicle, the cigarette lighter is the separating element from the 12V
mains, even if the device is equipped with the specific ON/OFF button.
WARNING: Before using the device, check the battery power status. Before each use proceed with charging the
battery. To maintain the device in good conditions, recharge the battery every 3 months (when not in use).
Recharging operations: to be able to charge the internal battery it is necessary to connect the universal switching adapter
(mod. UE60-140429SPA1 of FUHUA) to the electric network for approx. 360 minutes with the main switch to position 0.
The battery's autonomy when fully charged is approx. 70 minutes with continued operations.
LIGHT INDICATORS:
The device is provided with a light indicator (directly on the front panel) which allows you to view the operation of the device,
autonomy of the battery, and the charge phase in progress.
The light indications, which appear during operation, are indicated in table I.
TAB. I – INDICATOR LIGHTS DURING OPERATIONS
Back-light signals
Flashing Green Led
Steady Greed Led
Steady Red Led
Flashing Red Led
Steady Yellow Led
TAB. II – WRITTEN SIGNALS / BUTTON LED SIGNAL
Button LED signal /
written signal
ON/OFF button
Proximity Button
Using FLOVAC® disposable collection system: Before connecting the disposable collection system, remove the blu ring fitted on
the tank holder for a more comfortable insertion of the same container.
After opening the package, fully stretch the bag and then flatten it concentrically to eliminate as much air as possible.
-
Insert the bag and apply the cover to an appropriately sized reusable rigid container by pressing firmly around the entire
-
perimeter. Make sure that the system is completely sealed.
close the connector marked as "TANDEM" with the lid provided.
-
Connect the power source of the vacuum to the VACUUM port equipped with specific reusable conical fitting with "male"
-
connection.
Connect the patient tube to the PATIENT port of the cover
-
Before use, check all closures and make sure there are no leaks, starting the aspiration source. If the bag expands to fully
-
adhere to the walls of the rigid container and the cover bends towards the inside of the glass, the system is not leaking.
Start the aspiration and periodically check the filling level of the container. The overflow valve will cause the interruption of
-
aspiration if the aspirated fluids have reached the maximum filling level of the device.
When the float valve intervenes signalling the device is too full, the suction source must be disconnected within no more than
-
5 minutes.
Warning: The accidental inversion of connections may cause contamination for the operator and/or for the vacuum
generation equipment.
Phase
During rechanrge
During recharge
During battery
operation
Device automatically
turns off when the
battery is flat
During battery
operation
Function
Power on
Switch the ON/OFF key
Problem / Cause
Battery recharge running
Recharging cycle complete
Flat battery
Battery completely flat
Intermediate status
Colour
Green / Yellow / Red
Blue
22
Solution
Wait
Remove the device from the
switching adapter
Start recharging cycle
WARNING: During this signal, you
will hear a long, continuous beep
(duration of sound 0.8 sec / sound
frequency: every 8.5 sec, which
notifies the user regarding the
battery discharge.
When the device is restarted the
LED will flash red: begin the
battery recharge cycle
immediately
Guaranteed battery function /
Recharge when the red LED signal
comes on.
Position
Near the front panel key
LED located above the
"Proximity" key