Publicidad
Idiomas disponibles
Idiomas disponibles
Step1
1. PREPARATION
• Before assembling make sure that you will have enough space around the item.
• Use the supplied parts and hardware for the assembly.
• Before assembling please check whether all the required parts have been supplied as
per the exploded drawing on the opposite page.
• Notice: Some of the smaller parts may be pre-fitted to larger components, please ensure
you check carefully before contacting us regarding any missing parts.
STEP 1
2
STEP 2
5
ASSEMBLY STEPS
3
70
70
67
58
67
1
72
15
27
44
3
16
24
25
1
STEP 1:
Remove the Weight Guide Tubes (3) from the carton
and insert these into the Rear Base Frame (1) and
secure Bolts (72) from underneath.
Attach the Front Base Frame (2) to the Rear Base
Frame (1) by using 2 Hex Bolts (58), 2 Washers (67)
and 2 Nylon Nuts (70).
Ensure all bolts are tight before proceeding.
STEP 2:
Slide 2 Rubber Rings (25) onto the Weight Guide
Tubes (3). Once completed you can now slide 9
Weight Plates (16) down the Weight Guide Tubes
(3).
Now slide the Selector Shaft (5) down the middle
hole in the weight plates ensuring that the selector
shaft's holes with the tapered edge face backwards.
Line up with the weight selection holes underneath
each weight plate.
You can now slide the Selector Shaft Bushing (44)
down the Selector Shaft (5) ensuring that smaller
circle faces upwards. By simply lifting the Selector
Shaft (5) up slightly you must now slide the Selector
Shaft Pin (27) through the first hole on the Selector
Shaft (5) and the hole on the Selector Shaft Bushing
(44).
Once completed slide the Selector Shaft (5) back
down and slide the Top Weight Plate (15) down the
Weight Guide Tubes (3) and Selector Shaft (5) so
that it sits firmly on top. Now insert the Weight
Selector Pin (24) into any weight for the meantime.
Ensure all bolts are tight before proceeding.
33
Publicidad
