HOMCOM A91-176 Instrucciones De Montaje página 39

Idiomas disponibles

STEP 10

STEP 10: CABLE 36

Installing the pulley system:

1. Attach 1 open side of Cable 36 to the Leg Extension Frame (6) using 1 Hex Bolt (63), 2 Washers (68) and

1 Nylon nut (71) and thread cable under Pulley (J).

Step 3

2. Install Pulley (32) J and 2 Pulley Hooks (55) to the Front Base Frame (2) using 1 Hex Bolt (59), 2 Washers

(67) and 2 Nylon Nuts (70).

3. Install Pulley (32) H and 2 Pulley Hooks (55) to the Reverse U (20) using 1 Hex Bolt (59), 2 Washers (67)

and 2 Nylon Nuts (70).

Step 3

4. Install Pulley (32) K and 2 Pulley Hooks (55) to the Front Base Frame (2) using 1 Hex Bolt (59), 2 Wash-

ers (67) and 2 Nylon Nuts (70).

5. Install Pulley (32) L and 2 Pulley Hooks (55) to the Front Base Frame (2) using 1 Hex Bolt (59), 2 Washers

(67) and 2 Nylon Nuts (70).

6. Attach 1 x Chain (42) to the final open end of Cable 36.

7. Attach Chain (42) to Front Base Frame (2) using 1 x Pothook (29).

Threading the cable through the pulley system:

1. Thread Cable 36 under Pulley (32) J and up towards Pulley (32) H .

2. Thread Cable 36 over Pulley (32) H and back down towards Pulley (32) K .

3. Thread Cable 36 under Pulley (32) K and back up towards Pulley (32) L .

4. Thread Cable 36 over Pulley (32) L and back down.

EXERCISE INSTRUCTIONS

Step 3