Publicidad
Idiomas disponibles
Idiomas disponibles
IV. Protection function
1: Frost Protection Function:
In cooling mode, if the temperature of the EVA pipe sensor is too low, the unit will
automatically enter protection status; if the temperature of the EVA pipe sensor
rises to a certain temperature, it can automatically revert to normal operation.
2: Overflow Protection Function:
When water in the water pan exceeds the warning level, the unit will automatically
sound an alarm, and the "FULL" indicator light will flash. At this point, you need to
drainage the water (details see Drainage Instructions at the end of this chapter).
After the water is emptied, the unit will automatically return to the original state.
3: Protection Function of the Compressor
To increase the service life of the compressor, it has a 3-minute delay booting
protection function after the compressor is turned off.
V. Installation and adjustment
1.Installation：
Warning: before using the unit, keep it upright for at least two hours.
The unit can be easily moved in the room. In the moving process, ensure that the
unit is in the upright position and should be placed on a flat surface. Do not install
and use the unit in the bathroom or other humid environments.
1.1 Install the heat pipe assembly （as shown in Fig.1）
Figure 1
10
Publicidad
