HOMCOM 823-044V70 Manual Del Usuario página 13

5)
Elongate the exhaust pipe and snap the flat end of the exhaust pipe joints into the
hole of the window sealing
plate assembly (as shown in Fig.5 and Fig.6).
Notes：1: The flat end of the exhaust pipe joints must be snapped into place.
2: The pipe cannot be distorted nor has substantial turning (greater than 45
°). Keep the ventilation of the exhaust pipe unblocked.
Figure 5
Important Notice:
The length of the exhaust hose shall be 280~1,500mm, and this length is based on
the specifications of the unit. Do not use extension tubes or replace it with other
different hoses, or this may cause a malfunction. Exhaust host must be unblocked;
otherwise it may cause overheating.
VI. Drainage Instructions
This unit has two drainage methods: manual drainage and continuous drainage.
1. Manual drainage:
1) When the unit stops after the water is full, turn off the unit power and unplug the
power plug.
Notes：Move the unit carefully, so as not to spill the water in the water pan at the
bottom of the body.
2) Place the water container below the side water outlet behind the body.
3) Unplug the water plug, the water will automatically flow into the water container.
12
Figure 6